- High Quality Replacement Axle Shaft
- Meet OEM Specifications
- 2-1/2" Diameter
- Cast Ends Welded To Raw Turned Steel Tubes
- New Outer U-Joint Flange Installed
- Inner & Outer Non-Greaseable U Joints Pre-Installed
- Dependable Performance
- Made In The USA
When your 1963-1979 Corvette half shafts needed replacing, your only choice was to have yours rebuilt or rely on a re-manufactured shafts. The problem is you couldn't be sure they would be done right and the finish might not hold up to judging scrutiny (key among 1963-1972 investment grade show cars).
The solution are these new high quality replacement axle shafts from Eckler's Corvette. Our axle shafts meet OEM specifications and will pass judging scrutiny. Best of all they are made in the USA for reliable performance you can count on.
Tech Tip: To check your U-Joints, park your vehicle on a flat and level surface. Place your Corvette on jack stands or a lift. From underneath, rotate drive shaft or half shaft while watching U-Joints for excessive play. Also any time red "dust" is present on the U-Joint they should be replaced...this is rust!
Tech Tip: Replace your Corvette half shaft if there are any dents in the shafts, gouges or cracks in any part of the shafts, flanges or welds.
1963-79 Corvette replacement rear axle shaft with non-graspable u-joints and flange
1963-79 Corvette replacement rear axle shaft with non-graspable u-joints and flange
No questions.